107
Monitoring of DC analogue
measurements
&KDSWHU
9HULI\LQJVHWWLQJVE\VHFRQGDU\
LQMHFWLRQ
0RQLWRULQJRI'&DQDORJXHPHDVXUHPHQWV
A stabilized direct current generator and mA meter with very high accuracy for mea-
surement of direct current is needed in order to test the dc measuring module. The gen-
erator operating range and the measuring range of the mA meter must be at least
between -25 and 25 mA.
Prepare the terminal for verification of settings as outlined in section “Preparing for
test” in this chapter. Connect the current generator and mA meter to the direct current
input channels to be tested.
9HULI\LQJWKHVHWWLQJV
3URFHGXUH
&RQVLGHUWKHQHHGWREORFNRXWSXWVLJQDOV
&KHFNWKDWWKHYDOXHVSUHVHQW0,PRGXOHFRUUH
VSRQGVWRWKHPDJQLWXGHRILQSXWGLUHFWFXUUHQWZLWKLQWKHOLP
LWVRIGHFODUHGDFFXUDF\
The service value is available under the submenu:
6HUYLFH5HSRUW,26ORWQP0,0[0,[\9DOXH
&KHFNWKHRSHUDWLRQRI$'%6RU,'%6IXQFWLRQZKHQDSSOLFD
EOH&RPSDUHZLWKWKHH[SHFWHGYDOXHV
The operation of ADBS or IDBS function can be checked sepa-
rately with the setting of RepInt = 0. The value on the HMI must
change only when the changes in input current (compared to the
present value) are higher than the set value for the selected dead
band.
where:
QP
represents the serial number of a slot with tested mA input module
[
represents the serial number of a mA input module in a terminal
\
represents the serial number of a measuring channel on module x.
Summary of Contents for REL 551 2.3 Series
Page 16: ...10 Note signs KDSWHU 6DIHW LQIRUPDWLRQ ...
Page 44: ...38 Checking the binary I O circuits KDSWHU KHFNLQJ WKH H WHUQDO FLUFXLWU ...
Page 52: ...46 Checking the self supervision signals KDSWHU QHUJLVLQJ WKH WHUPLQDO ...
Page 140: ...134 Testing the interaction of the distance protection KDSWHU 7HVWLQJ WKH SURWHFWLRQ V VWHP ...
