ABB PVS800-57-0100kW-A, Hardware Manual, Page: 67 / 180

Mechanical installation 65
Moving the unit
Move the unit by crane (A), fork-lift or pallet truck (B), or on rollers (C) as shown below.
If the cabinet needs to be laid on its back, it must be supported from below beside the
cubicle seams as shown below. a) support, b) cabinet back panel.
Note: Transportation of
a unit on its back is only allowed if the unit is equipped for such transportation at the
factory.
Use the steel lifting bars attached to the top of the cabinet. Insert the lifting ropes or slings into
the holes of the lifting bars.
The lifting bars can be removed (not mandatory) once the cabinet is in its final position.
If the
lifting bars are removed, the bolts must be refastened to retain the degree of protection
of the cabinet.
The unit is to be moved only in the upright position. The centre of gravity is high. Be therefore
careful when transporting the unit. Avoid tilting the cabinet.
If using a pallet truck, check its load capacity before attempting to move the unit.
A B C
A
B
a
b