Operation Manual / Power2 850-M / High-pressure stage
5 Monitoring during operation / 5.1 Lubricating oil pressure
© Copyright 2022 ABB. All rights reserved.
HZTL4063_EN
Rev.F
March 2022
5
Monitoring during operation
5.1
Lubricating oil pressure
CAUTION
Assuring lubricating oil pressure
Serious damage to the engine or property can result from a missing or insuf-
ficient lubricating oil supply.
u
The lubricating oil pressure must be monitored during operation and the
necessary pressure assured at the oil inlet.
Fig. 14: Lubricating oil pressure measuring point
The measuring point M is at the oil supply channel of the high and low-pressure stage that is
not used for the oil supply.
Power2
Status
Engine
Status
Low-pressure and high-pressure stage
Oil pressure at measuring
point M
p
oil, in
[bar]
850
Engine run-
ning
Admissible
1.3 ... 2.5
Temporarily admissible
(<15 min) after engine start (cold oil)
1.3 ... 5.0
Temporarily admissible (<1 h )
-> Warning signal
1.0 ... 1.3
Not admissible
-> Alarm signal
->
stop the engine imme-
diately
< 1.0
Engine
stopped
Pre-lubrication
1.3 … 2.5
Post-lubrication
1.3 … 2.5
Long-term lubrication
< 0.7
Table 12: Oil pressure range
Metering orifices are installed in the oil inlet of the low-pressure stage and the high-pressure
stage in order to safeguard the oil pressures.
Page
38
/
104
Summary of Contents for PT004149
Page 2: ......
