ABB PST Series, Installation And Commissioning Manual

Page: 16 / 178

16
1SFC132003M0201
Configuration
4XLFNVWDUW
&KDSWHU
&RQILJXUDWLRQ
1 Enter the Application Setting by pressing left selection
key twice. Press
6HOHFW
using the left selection key.
2. Select the appropriate type of load using navigation
keys.
3. Press
6WRUH6HW
and
1H[
t to continue or
%DFN
to previ-
ous parameter using the selection keys.
4. Set the Setting Ie using the navigation keys.
In Line connected = rated motor current
Inside Delta connected = 58% (
) of the rated
motor current.
5. Press
6WRUH
and
1H[W
to continue or
%DFN
to previous
parameter using the selection keys.
6. Set the required overload class using the navigation
keys.
7. Press
6WRUH
and
1H[W
to continue or
%DFN
to previous
parameter using the selection keys.
8. If an external by-pass contactor is used set
([W%\3DVV
to
<HV
using the navigation keys. (PST30...300 only).
9. Press
6WRUH
and
1H[W
to continue or
%DFN
to return to
previous parameter using the selection keys.
10.Select
<HV
if ready or
7XQH6HW
if ramp times, initial
voltage, current limit etc. needs to be adjusted using
selection keys.
6WDUWRIWKHPRWRU
1 Switch on the main voltage.
2. Give start command to the softstarter.
(To start the softstarter from the keypad, enter the
LOCAL CONTROL menu, select
6WDUW6WRS
and press
6WDUW
. The motor must be stopped before leaving this
menu.)
#RRNKECVKQP5GVVKPI
5GNGEV $CEM
)LJXUH $SSOLFDWLRQVHWWLQJPHQX
%GPVTKHWICN 2WOR
5VQTG5GV $CEM
)LJXUH &HQWULIXJDOSXPS
%GPVTKHWICN 2WOR
0GZV $CEM
)LJXUH &HQWULIXJDOSXPSVWRUHG
G #
5VQTG
)LJXUH 6HWWLQJ,H
1 3
e
G #
0GZV $CEM
)LJXUH 6HWWLQJ,HVWRUHG
1.%NCUU
5VQTG
)LJXUH 2/&ODVV
1.%NCUU
0GZV $CEM
)LJXUH2/FODVVVWRUHG
'ZV$[2CUU 0Q
5VQTG
)LJXUH ([WHUQDO%\SDVV
'ZV$[2CUU 0Q
0GZV $CEM
)LJXUH([WHUQDO%\SDVVVWRUHG
4GCF[!
;GU 6WPG5GV
)LJXUH 5HDG\7XQH6HW