ABB PM5630, User Manual

Page: 14 / 33

ABB | E-kit
14 | © 2022 ABB | - 1SDH002203A1002 Ethernet communication interface (ports ETH1 and ETH2)
Setting of static
IP address (recommended)
The IP address of E-kit is configured by means of the keypad. The IP address is expressed on the display in
form A1.A2.A3.A4, the subnetwork in form N1.N2.N3.N4 and the network gateway in form G1.G2.G3.G4.
An example is given below:
IP 192.168.0.113
→
A1=192, A2=168, A3=0, A4=113
subnetwork 255.255.255.0
→
N1=255, N2=255, N3=255, N4=0
gateway 192.168.0.1
→
G1=192, G2=168, G3=0, G4=1
Power-up E-kit and press button CFG to access the configuration
screen.
Press the arrow key to select the port (Eth1 or Eth2)
Press CFG to set the mode with static address
Press CFG to view the first parameter
The parameter indicator will start to flash Use the arrow keys to
change the value.
Press OK to view the second parameter
Press CFG to edit the first parameter. Use the arrow keys to
change the value.
Repeat these steps to configure parameters A3, A4, N1, N2, N3,
N4, G1, G2, G3, G4.
Press OK to terminate the configuration process
Press OK again to confirm the changes
The changes will be implemented once OK has been pressed for
the second time. Shut down the CPU and then reboot to make the
changes effective