ABB OmniCore S Series, Operating Manual

Page: 90 / 236

Creating a new program
This section describes how to create a new program.
1 On the start screen, tap Code , and then select Modules from the menu.
2 On the Context menu , tap New Program .
xx1900000214
If there was already a program loaded, a warning dialog appears:
• Tap Save to save the loaded program.
• Tap Don't Save to close loaded program without saving it, i.e. delete
from program memory.
• Tap Cancel to leave the program loaded.
3 Tap Main Module .
4 Add the instructions and routines to the program.
5 Tap Check Program .
6 Tap Modules .
7 On the Context menu , tap Save as .
8 Tap a name for the program in the File Name field.
9 Select the location for saving the new program file.
10 Tap Save .
The program is saved.
Saving a program
This section describes how to save a loaded program to the controller hard disk.
A loaded program is automatically saved in the program memory, but saving to
the controller hard disk is an extra precaution.
1 On the start screen, tap Code , and then select Modules from the menu.
2 On the Context menu , tap Save as .
Continues on next page
90 Operating manual - OmniCore
3HAC065036-001 Revision: E
© Copyright 20192020 ABB. All rights reserved.
6 Programming and testing
6.3.1 Handling of programs
Continued