ABB OmniCore C90XT, Product Manual

Page: 79 / 450

3.5.7 Network connections on OmniCore
Connections on the OmniCore controller
The following figure illustrates the available Ethernet port connectors on the
controller.
Note
For information regarding location of the Ethernet port connectors, see
Connectors on the OmniCore C90XT controller on page 62 .
3 1 1 4 2 1
xx1800003138
Description Label
Port to the robot's private network. Intended for
connecting ABB Scalable I/O units and network
based process equipment to the controller. I/O + LAN + ETHERNET
SWITCH 1
This port only exists if the wired variant of the Con-
nected Services Gateway is used. Intended for
connecting to the robot's Ability™ network. ABB Ability™ 2
WAN port that can be used to host a public industri-
al network. WAN 3
Port to the robot's private network. The MGMT port
shall be used by service personnel in close proxim-
ity to the controller, with a single client connected
to the controller. MGMT (Management) 4
Note
The management port shall never be used for more
than one client at a time. ABB Robotics assumes
no responsibility for any errors/hazards that may
appear when more than one client is attached to
the management port.
A factory wide I/O network should be connected to the Ethernet port WAN on the
controller.
Continues on next page
Product manual - OmniCore C90XT 79
3HAC073706-001 Revision: D
© Copyright 2020-2021 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Network connections on OmniCore