Installation and Start-up Guide for NPBA-01
F-1
Appendix F – NPBA-01 Type Definition Program
This appendix contains information for setting up a Siemens ET 200
system for use with an ACS 600.
The program listed below should be typed in and saved to the same
directory location at the PROFIBUS master as the controller programs.
The file should be named PROFI@TX.200 (where X is substituted with
the ET 200 package language, eg. D = German, E = English, I = Italian,
etc.). The program adds the ACS 600 to the ET 200 Slave Selection
list. After this, the parameters of the new slave selection should be set
according to Table F-1 (next page).
Typbeschreibungsdatei PROFIDRIVE-Slave
V4.0;
PROFIDRIVE-SLAVE ;
SIEMENS ;
SIMATIC_S5;
ET200 ;
ET200U/DP ;
02069;
J;
J;
N;
J;
J;
N;
N;
N;
J;
N;
N;
N;
N;
N;
00020;
0001011111;
032;
032;
032;
016;
007;
PV000;
PSL000;
KV000;
SY;
DKM000;
