Note
Action
Note
If the pressing force is outside the given
range or if the pinion "jumps" in bit by bit,
it must be dismounted, checked and oiled
before it is fitted again!
Press the pinion onto the new motor.
Check the pressing force!
For an axis with diameter of 15.5 mm use:
•
minimum pressing force = 18.5 kN
•
maximum pressing force = 39.5 kN.
6
For article number see:
•
Required equipment - tools etc. on
page 371
Measure the distance between the motor
flange and the outer surface of the pinion
with the
measuring tool
.
7
For article number see:
•
Modify the distance with
shims
to obtain the
same distance as measured when dismount-
ing the old motor (+0-0.05 mm)
8
Refitting motor axis 5
Use this procedure to refit motor axis 5
Note
Action
Clean the joints that have been opened. See
Cut the paint or surface on the robot before
replacing parts on page 219
1
How to remove the pinion is described
in:
•
Removing the pinion on motor axis
5 on page 374
How to fit the pinion is described in:
•
Refitting the pinion on motor axis
5 on page 375
Note
The pinion of motor axis 5 is matched with
the bevel gear for axis 5. When fitting a new
motor the pinion from the old must be fitted
on the new motor!
2
For article number see:
•
Additional equipment - Foundry
Prime on page 371
xx1000000623
Apply
Loctite 574
on the motor flange.
3
Part:
•
A: Loctite 574
Continues on next page
376
Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.6.5 Replacing motor axis 5
Continued
Summary of Contents for IRB 6640 Foundry Prime
