ABB i-bus
®
KNX
Parameters
46 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page
7.2.2.7
DPT
This parameter defines the KNX data point types (DPT). For a description of all the data point types
available in the ETS application, click
The selected DPT is shown in the name of the corresponding Group Object.
Option
7.001: pulses
DPT 7.001
x
Variable for the listed data point type
Note
Be sure to select the correct DPT based on the associated Modbus data point.
Prerequisites for visibility
•
This parameter is in the
Config Device x
parameter window.
7.2.2.8
Read Function
This parameter is used to define which Modbus function codes are selected.
The function code tells the server which memory type (i.e. register, coils, etc.) to access and read.
Option
1: Read Coils
2: Read Discrete Inputs
3: Read Holding Registers
4: Read Input Registers
-
Prerequisites for visibility
•
This parameter is in the
Config Device x
parameter window.
