ABB i-bus KNX FCL/S 1.6.1.1, Product Manual

Page: 7 / 104

ABB i-bus
®
KNX
General
FCL/S x.6.1.1 | 2CDC508116D0203 5
1.2 Product and functional overview
The FCL/S 1.6.1.1 and FCL/S 2.6.1.1 Blower Actuators are modular installation devices in Pro M design 4-
and 8-module widths for installation in a distribution board. Connection to the ABB i-bus KNX is estab-
lished via the front bus connection terminal. The devices require no auxiliary voltage. The assignment of
physical addresses as well as the parameterization is carried out with Engineering Tool Software ETS.
The FCL/S 1.6.1.1 1-fold actuator controls a single-phase fan with up to three fan speeds via a step or
changeover control. The FCL/S 2.6.1.1 2-fold actuator can control a second fan. The actuators ensure that
no two fan speeds can be switched on simultaneously.
The outputs on the 2-fold actuator that are not used for the fan can be used to switch electrical loads.
The device receives its control value via the ABB i-bus
®
KNX, e.g. from a room thermostat.
The following controls are feasible:
FCL/S 1.6.1.1:

One 3-speed fan plus one switch output
FCL/S 2.6.1.1:

Two 3-speed fans plus two switching outputs

One 3-speed fan plus five switching outputs