Operation Manual / TPS44-H.. - TPS52-H..
8 Periodic maintenance work / 8.2 Cleaning components mechanically
© Copyright 2021 ABB. All rights reserved.
HZTL4037_EN
Rev.G
June 2021
8.2.3
Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
u
Do not breathe in these substances and avoid contact with the skin.
u
Ensure proper ventilation.
u
Observe the information in the material safety data sheet for the operat-
ing materials and supplies.
u
Wear personal protective equipment (PPE) according to the material
safety data sheet.
u
Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accord-
ance with the description below.
Fig. 20: Cleaning the compressor casing, diffuser mechanically
72000
Compressor casing
79000
Diffuser
u
Steam-clean the above-mentioned components or soak in diesel oil or water with house-
hold cleaning agents. After soaking, remove contamination with a brush.
u
Dry components completely.
u
Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the tur-
bocharger.
u
Dispose of contaminated water and cleaning agents in accordance with the information
in the material safety data sheet.
Page
56
/
109
