ABB FPTC-01, User Manual

Page: 88 / 108

Technical data 87

Acceptance test reports
You must store the signed acceptance test reports in the logbook
of the machine. The report must include, as required by the
referred standards:
•
a description of the safety application (including a figure)
•
a description and revisions of safety components that are used
in the safety application
•
a list of all safety functions that are used in the safety
application
•
a list of all safety related parameters and their values
•
documentation of start-up activities, references to failure
reports and resolution of failures
•
the test results for each safety function, checksums, date of
the tests and confirmation by the test personnel.
You must store any new acceptance test reports performed due to
changes or maintenance in the logbook of the machine.

Competence
The acceptance test of the safety function must be carried out by a
competent person with expertise and knowledge of the safety
function as well as functional safety, as required by IEC 61508-1
clause 6 and Ex regulations. The test procedures and report must
be documented and signed by this person.

Ambient conditions
For the environmental limits for the safety function and the drive,
refer to the hardware manual of your drive.

Reporting problems and failures related to safety
functions
Contact your local ABB representative.