ABB FOCH, Hardware Manual, Page: 17 / 38

Installation
Contents of this chapter
This chapter contains mechanical and electrical installation instructions.
Planning the installation
See chapter Technical data (page 27) for allowed ambient conditions, maximum cable
length between the drive output and the filter, maximum motor cable length and other
technical data.
See chapter Dimension drawings (page 31) for the dimensions. Non-enclosed (IP00)
filters can be mounted in an upright position with the output terminals up or down.
Other mounting positions are possible with an extra fan. Enclosed (IP22) filters must
be installed in the upright position with the air outlet gratings on the upper part of
the side plates (and guiding the air downwards).
The figure below shows the mounting position alternatives of a non-enclosed (IP00)
filter.
4
Installation 17
10