ABB FlexMT, Product Manual, Page: 213 / 246

13.2.2.2 Operation
You operate the control panel with the help of menus and keys. You select an
option, eg operation mode or parameter, by scrolling the
or keys until
the desired option is visible in the display and then pressing the key. With the
key, you return to the previous operation level without saving the made
changes. The basic control panel has five panel modes: Output mode, Reference
mode, Parameter mode, Copy mode and Fault mode.
When a fault or alarm occurs, the panel goes automatically to the Fault mode
showing the fault or alarm code. You can reset the fault or alarm in the Output or
Fault mode. After the power is switched on, the panel is in the Output mode, where
you can start, stop, change the direction, switch between local and remote control
and monitor up to three actual values (one at a time). To do other tasks, go first to
the Main menu and select the appropriate mode.
3HAC051768-001 Revision: - 213
© Copyright 2014-2014 ABB. All rights reserved.
13 Appendix A: Configuration
13.2.2.2 Operation