ABB Fimer PVS980-58-4348kVA-I, Commissioning And Maintenance Manual, Page: 30 / 58

28 Start-up and operation
Starting and stopping the inverter

Inverter control with parameter
To enable inverter operation, set parameter 189.01 Inverter operation value to Enable . You
can edit the parameter value directly in the parameter group 189
Inverter Control
with the
control panel or with a computer through USB or SCADA.

Inverter control with Start/Stop switch
To enable the inverter operation, turn the Start/Stop switch to 1-RUN. To disable the
inverter operation, turn the Start/Stop switch to 0-STOP.

Inverter control with SCADA
For more information, refer to the
Firmware manual
for the parameter 189.07.