ABB ESI-S, Installation, Operation And Maintanance Manual, Page: 93 / 223

Manual Energy Storage Inverter ESI-S  The ESI-Manager user interface 93
Fault analysis can be done by consulting the ‘ESI Monitoring’ menu [/Welcome/ESI
Monitoring]. For more information on the ‘ESI monitoring’ menu, refer to
Section 7.10 .
If the inverter is set up for remote control operation, the local start/stop command has
no effect.
Disable the digital inputs to override the remote control [/Welcome/Settings/Customer
set./Digital inputs].
7.8 The ‘Measurements’ menu
This menu allows monitoring a variety of variables (e.g. voltage, current …) in a variety
of formats (e.g. RMS-values, spectra, time domain waveforms). Its submenus are
discussed next.
In multi-unit inverters, several parameters are measured by the individual units. In order
to consult measurements from a specific unit, select the unit with the ‘Select Unit’ option
(where available). The order of the unit is determined by the DIP switch unit
identification setting at the moment of commissioning.
7.8.1 The ‘Overview’ menu
The Overview menu summarizes the following characteristic parameters ( Table 40 ).
These parameters are expressed as numerical values in a list.