ABB DPA Upscale RI Series, User Manual

Page: 113 / 133

Section-9
04-3006_S9_OPM_ABB_DPA_UPSCALE_RI_10-80kW_EN_150316.doc
Page 2/6 ABB
Modifications reserved
9.1 OPTIONS
9.1.1 Introduction
The DPA UPSCALE
TM
is provided with the following accessories:

REMOTE SHUT DOWN FACILITIES

GENERATOR ON FACILITIES

1 CUSTOMER IN FUNTIONS (ON REQUEST)

TEMPERATURE SENSOR FOR TEMP. DEPENDING BATTERY CHARGERING

SOFTWARE FOR AUTOMATIC SHUTDOWN AND MONITORING

SNMP INTERFACES FOR NETWORK MANAGEMENT AND REMOTE MONITORING
9.1.2 Remote SHUT DOWN
The REMOTE SHUT DOWN must use a normally closed contact, which opens to operate the remote shut down
sequence.
The remote shutdown on terminal port X1/7.. X1/8 is located at the bottom of the DPA UPSCALE
TM
frame on
communication card with terminal blocks X1 …X
2. See section 3 / 1.2.1 for details.
In order to allow removal, maintenance or testing of any remote shut down facility without disturbing the normal
operation of the UPS, it is recommended that a terminal block, with linking facilities, be installed between the UPS
and the stop button.
1. Use a screened cable with 1 pair (section of wires 0.5 mm 2 ) and maximum length of 100 m.
2. Connect the cable as shown in Fig. 1.2
REMOTE SHUT DOWN SWITCH
(N.C. = Normally Closed)
UPS
Remote shut down
(X1)
Terminal Block
Fig 1.2 Drawing of the wiring for the REMOTE SHUT DOWN SWITCH.
X
1
X
2
X1/7
X1/8