Operation
ABB, 1SBC159102M0202
21
6.8 Copying an Application
To copy an application from one CP420 to another CP420, select
Copy
from
the system menu. Set the dip switch
SW7 = ON
and connect the two operator
terminals with a download cable. After the self-test, the system menu will be dis-
played on the screen.
Select
Copy
in the system menu from the operator terminal with the application
to be copied. The operator terminal will prompt for a password: enter the pass-
word set in CP400Soft from
Application/Workstation Setup
. Once the correct
password is entered, the CP420 starts to copy the application to the other
CP420.
For information about setting a password, please see section
The following appears on the screens during the copying:
Note:
When copying for the first time, make sure to first run the application once, or
else the copy function will not work.
