ABB CoriolisMaster FCM2000, Operating Instructions Manual

Page: 28 / 128

Installation
28 CoriolisMaster FCM2000 D184B111U02
Pos: 27 /Überschriften/1.1/1-spaltig/M - O/Montage @ 0\mod_1129875293961_3101.doc @ 3199 @ 22
4.2 Installation
Pos: 28.1 /Überschriften/1.1.1/1-spaltig/Allgemeine Hinweise zur Montage @ 8\mod_1177424551999_3101.doc @ 86297 @ 33
4.2.1 General information on installation
Pos: 28.2 /Montage/Allgemein/Allgemeine Hinweise zur Montage @ 7\mod_1171883690328_3101.doc @ 68475 @
The following points must be observed for the installation:
• The flow direction must correspond to the identification if present.
• The devices must be installed without mechanical tension (torsion, bending).
• Install flange units with coplanar counter flanges and use only appropriate gaskets.
• Use only gaskets made from a compatible material for the fluid and fluid temperature or use
only gasket material compatible with hygienic designs
• Gaskets must not extend into the flow area since possible turbulence could influence the
device accuracy.
• The pipeline may not exert any unallowable forces or torques on the device.
• Do not remove the plugs in the cable connectors until you are ready to install the electrical
cable.
• Make sure the gaskets for the housing cover are seated properly. Carefully seal the cover.
Tighten the cover fittings.
• Install the separate transmitter at a largely vibration-free location.
• Do not expose the transmitter to direct sunlight. Provide appropriate sun protection as
necessary.
Pos: 28.3 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830 @