ABB CoreSense M10, Installation Manual

Page: 65 / 96

Configuring CoreSense M10
65
Modifying default passwords
With the CoreSense™ M10 system, parameters and functions are made available depending on the
password used to access the system (rather than user names).
For cybersecurity reasons, it is absolutely mandatory to change the default passwords. Not doing so
could expose your entire network to cyberattacks.
The default operator and administrator passwords are:
• Operator
Ack
• Administrator
Admin
To modify passwords:
1
From the CoreSense M10 dashboard (see Figure 47), click
Settings
. The Settings page appears.
—
Figure 48
CoreSense M10 Settings page
2
Click
Administration settings
.
The first time that you try to access this page, you will be asked to enter a password. Enter the
administrator password shown above. The Administration settings page appears.
3 In the General settings section, enter passwords for both operators and administrators.
NOTICE
Passwords accept letters (including capitals) and numbers,
but not special characters.
Passwords cannot be more than 25 characters long.