Modifications reserved
Page 46/94
6.4.6
Module selection screen
By pressing the button F (
) directs the user to the module selection screen from
where it is possible to select the module and start the navigation (status and measurements) on module
level.
The module selection screen will show the amount of module in the system show the status of each
module as follows:
•
Green:
Active. The UPS module is running in double conversion mode (or bypass
mode).
•
Grey:
Module switched OFF (load-OFF), but physically present in the frame. (If a
module is not physically present in the frame, no icon appears).
•
Light blue:
Standby. The UPS module is in standby (inverter OFF). Only possible when XTRA
VFI is enabled.
•
Red:
Alarm. UPS module with general alarm.
Example with 5 modules all in operation.
Example with 20 modules all in operation.
Example with 5 modules, 01-03 in operation, 04
switched OFF (load-OFF), and 05 with general
alarm.
Example with 30 modules all in operation.
By touching on one of the icons the user gets access to the module level. The mimic diagram of the
selected module will appear. From there the navigation gives the possibility to access specific
measurements and check the status of the selected module.
Summary of Contents for Conceptpower DPA 500
