Introduction
6
Power Panel FT50 User's manual V1.19
1.2 Information about this document
This document is not intended for end customers! The safety guidelines required for end customers
must be incorporated into the operating instructions for end customers in the respective national lan-
guage by the machine manufacturer or system provider.
1.2.1 Organization of notices
Safety notices
Contain
only
information that warns of dangerous functions or situations.
Signal word
Description
Danger!
Failure to observe these safety guidelines and notices will result in death, severe injury or substantial damage to property.
Warning!
Failure to observe these safety guidelines and notices can result in death, severe injury or substantial damage to property.
Caution!
Failure to observe these safety guidelines and notices can result in minor injury or damage to property.
Notice!
Failure to observe these safety guidelines and notices can result in damage to property.
General notices
Contain
useful
information for users and instructions for avoiding malfunctions.
Signal word
Description
Information:
Useful information, application tips and instructions for avoiding malfunctions.
1.2.2 Guidelines
European dimension standards apply to all dimension diagrams.
All dimensions in mm.
Unless otherwise specified, the following general tolerances apply:
Nominal dimension range
General tolerance per
DIN ISO 2768 medium
Up to 6 mm
±0.1 mm
Over 6 to 30 mm
±0.2 mm
Over 30 to 120 mm
±0.3 mm
Over 120 to 400 mm
±0.5 mm
Over 400 to 1000 mm
±0.8 mm
