ABB AWIN GW100, User Manual

Page: 42 / 68

VIEW D EVIC ES CO NFIGU R ATIO N
38 3BNP1029 12 C
Field Description
TV Displays the Tertiary Value of the corresponding HART device.
QV Displays the Quaternary Value of the corresponding HART device.
Battery Life Displays the expected remaining life of the battery powering the devices
(if “65535” is displayed, the device is line powered with a power supply or
waiting for battery life information to be provided by the device).
Neighbors The number of neighbors a WirelessHART device can communicate with.
Timestamp In (hh:mm) format, is the time when the data was most recently polled.
Latency Measure of time it takes to respond and update all the corresponding
data fields (measured in seconds).
Bandwidth In (msec/packet) format, is the available data rate to the corresponding
device.
Joins The number of times a device connected to the gateway since bootup.
Command 3 period HART command 3 continuous burst period.
Command 3 status HART command 3 burst status (ON/OFF).
Active Pipe This field shows the status of pipe for a device.
Note. The Active Pipe option is available in firmware version 1.5-1.
Fast Pipe Control Fast pipe can be enabled and disable for a device using this function.
Notes:
Only one device can have a pipe at any point in time.
The Fast Pipe Control option is available in firmware version 1.5-1.
6.7.1 Delete a Device
To remove a device from the list (i.e. WirelessHART network), right-click on the disconnected
device in
Devices page and a delete option will appear. Select this option to confirm.
Only devices that are not connected may be deleted from the device list.
To delete an active device, power down the device and wait until the status col-
umn indicates the device is disconnected and the row is red.
6.7.2 Edit Slave Device
To edit a slave device, click Edit Slave IDs button and enter the new ID number in the field
next to each device. When finished, click OK button to save the changes, or click Cancel but-
ton to discard changes.
It may take a few seconds for the new ID numbers to take effect.