ABB AWIN GW100, User Manual

Page: 36 / 68

WIRELES SHART PROF ILE CONF IGU RATION CO NFIGU R ATIO N
32 3BNP1029 12 C
Table 7: Information screen fields
Field Description
LAN IP Address The logical address of the LAN port. The IP address
uniquely identifies this device on the network.
LAN Subnet Mask Bit mask used to tell how much of an IP address identi-
fies the subnetwork the host is on, and how much
identifies the host. This subnet mask applies to the
10/100 Mbps LAN port.
LAN Default Gateway A node on the network that serves as an access point
to a different network for the LAN port.
LAN MAC Address (Media Access Control address, MAC address) is the
address for the network card.
WirelessHART AP MAC Address MAC address for the WirelessHART radio in the gate-
way.
Firmware Version Version of software loaded into the AWIN GW100.
Hardware Version Shows version and revision level of the circuit boards.
6.5 WirelessHART Profile Configuration
1. Click Configuration > WirelessHART > Gateway Profile in the left navigation column to
view and select the WirelessHART Gateway Profile.
Figure 13: Gateway Profile Configuration screen
There are five profiles available as shown in Table 8.