Section 4
Getting started
4.1
Connecting cables
1.
Check that the power switch is in the OFF position.
Later product versions have an earthing screw near the
antenna connector. When available, it has to be used for the
protective earthing.
2.
Connect the Ethernet cable between the device’s Ethernet LAN connector and
the computer used for the configuration.
3.
Connect the power supply to the device.
4.
Toggle the power switch to ON position.
The power/error LED and function LED should turn on immediately after the
power switch is turned on.
After the system has initialized, the function LED starts to flash.
4.1.1
Connection principle
The device has configurable network interfaces.
•
Ethernet LAN/WAN port
•
Mobile WAN cellular interface
The device supports cellular connectivity (2G, 3G, LTE) allowing the use of
wireless applications. The Mobile WAN interface is used for connecting the device
to the cellular network. The Ethernet LAN is used for connecting other Ethernet
devices to the device's local network.
The WAN interfaces can be configured to create a redundant system where one
WAN automatically receives traffic if the other one goes down. For example, if the
primary Ethernet connection goes down, the traffic is automatically switched to
mobile WAN (secondary connection) and back when the Ethernet interface comes
up again.
1MRS758456 H
Section 4
Getting started
ARG600 Single SIM Variant
21
User Manual
