290 Parameters
Selects the optional warning message for signal edge counter
2.
Edge counter 2
exceeded
. The message text can be edited on the
control panel by choosing Menu – Settings – Edit texts.
3
Counted main
contactor
.
11
Counted output
relay
.
12
Counted motor
starts
13
Counted power ups
14
Counted DC
charges
15
Displays the actual present value of value counter 1.
The value of the source selected by parameter
is read at one-second intervals and added to
the counter. A divisor can be applied to the count (see
).
When the counter exceeds the limit set by
, bit 4 of
is set to 1.
is also given if enabled by
.
The counter can be reset from the Drive composer PC tool, or
from the control panel by keeping Reset depressed for over 3
seconds.
-
-2147483008 …
2147483008
Actual present value of value counter 1.
-
Sets the limit for value counter 1.
With a positive limit, bit 4 of
is set to 1
(and a warning optionally generated) when the counter is
equal or greater than the limit.
With a negative limit, bit 4 of
is set to 1
(and a warning optionally generated) when the counter is
equal or smaller than the limit.
0 = Counter disabled.
0
-2147483008 …
2147483008
Limit for value counter 1.
-
No.
Name/Value
Description
Def
/
FbEq16
Summary of Contents for ACS880-x04
