194 Parameters
(Visible when
See parameter
.
10.000 mA
(Visible when
See parameter
-
(Visible when
See parameter
.
(Visible when
See parameter
0.000 mA
(Visible when
See parameter
0.100 s
(Visible when
See parameter
.
0.0
(Visible when
See parameter
.
100.0
(Visible when
See parameter
0.000 mA
(Visible when
See parameter
.
10.000 mA
19
Selection of local and external control location sources and
operating modes.
See also section
(page
).
Displays the operating mode currently used.
See parameters
.
This parameter is read-only.
-
Zero
None.
1
Speed
Speed control (in DTC motor control mode).
2
Torque
Torque control (in DTC motor control mode).
3
Min
The torque selector is comparing the output of the speed
controller (
Torque reference speed control
) and torque
reference (
) and the smaller of the
two is used.
4
Max
The torque selector is comparing the output of the speed
controller (
Torque reference speed control
) and torque
reference (
) and the greater of the
two is used.
5
Add
The speed controller output is added to the torque reference.
6
Voltage
DC voltage control.
7
Scalar (Hz)
Frequency control in scalar motor control mode.
10
Scalar (rpm)
Speed control in scalar motor control mode.
11
Forced magn.
Motor is in magnetizing mode.
20
Selects the source for external control location EXT1/EXT2
selection.
0 = EXT1
1 = EXT2
EXT1
EXT1 (permanently selected).
0
EXT2
EXT2 (permanently selected).
1
FBA A MCW bit 11
Control word bit 11 received through fieldbus interface A.
2
No.
Name/Value
Description
Def
/
FbEq16
Summary of Contents for ACS880-x04
