Application macros 103
Default parameter settings for the PID control macro
Below is a listing of default parameter values that differ from those listed for the
Factory macro in
(page
Note:
The macro selection does not affect parameter group
Parameter
PID control macro default
No.
Name
4.000
40.07 Set 1 PID operation mode
0.040 s
40.35 Set 1 derivation filter time
1.0 s
Summary of Contents for ACS880-x04
