ABB ACS880 Series, Firmware Manual

Page: 555 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
1 = 1 s / 100 = 1 s Cleaning deceleration time in seconds. 0.00 ... 30000.00 s
100.00% / real32 Defines the motor current reference setting used
during acceleration period of every cleaning cycle.
This helps to produce higher starting torque and assist
acceleration.
Note: For the Acceleration boost to work, parameter
81.02 Pump cleaning option sel , bit-7 must be set to 1.
Acceleration boost
current 81.35
10 = 1% / 100 = 1% Acceleration boost current. 0.00 ... 300.00%
Not selected / unit32 Defines source for the cleaning abort command.
The cleaning operation can be interrupted at any time
with abort command. In such case, ESP control program
will immediately switch to production mode. Cleaning abort
source 81.40
0 Cleaning abort source is not selected. Not selected
1 Cleaning abort source is selected. Selected
2 Digital input DI1 ( 10.2 DI delayed status , bit 0). DI1
3 Digital input DI2 ( 10.2 DI delayed status , bit 1). DI2
4 Digital input DI3 ( 10.2 DI delayed status , bit 2). DI3
5 Digital input DI4 ( 10.2 DI delayed status , bit 3). DI4
6 Digital input DI5 ( 10.2 DI delayed status , bit 4). DI5
7 Digital input DI6 ( 10.2 DI delayed status , bit 5). DI6
10 Digital input/output DIO1 ( 11.2 DIO delayed status , bit
0).
DIO1
11 Digital input/output DIO2 ( 11.2 DIO delayed status , bit
1).
DIO2
See Terms and abbreviations (page 169) . Other [bit]
Motor current % /
unit32 Defines the source for the supervision low signal.
The value from this parameter is then compared with
the limit set in parameter
81.42 Supervision low limit .
If the observed signal is lower than the limit for the
time period set in parameter
81.43 Supervision low
delay , then cleaning procedure is interrupted. The ESP
control program will immediately switch to production
mode. The supervision low is not active during off-time
period.
Note: For the supervision low function to work,
parameter
81.02 Pump cleaning option sel bit-11 must
be set to 1.
Supervision low
signal src 81.41
0 Zero NULL
1 12.12 AI1 scaled value (page 226) . AI1 scaled
2 12.22 AI2 scaled value (page 228) . AI2 scaled
3 3.5 FB A reference 1 (page 179) . FBA1 ref
4 3.6 FB A reference 2 (page 179) . FBA2 ref
5 3.9 EFB reference 1 (page 179) . EFB1 ref
Parameters 555