ABB ACS880-87LC-3200A, Hardware Manual

Page: 99 / 132

Applicable standards
The converter complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standards EN 61800-5-1.
Safety of machinery. Electrical equipment of machines. Part 1: General require-
ments. Provisions for compliance: The final assembler of the machine is responsible
for installing
•EN 60204-1:2006 +
A1:2009 + AC:2010
- an emergency-stop device.
Degrees of protection provided by enclosures (IP code)
•EN 60529:1991
Low-voltage switchgear and controlgear assemblies
•EN/IEC 61439:2011
Semiconductor converters - General requirements and line commutated converters
•EN/IEC 60146
Electronic equipment for use in power installations
•EN/IEC 50178
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
•IEC 60664-1:2007
Wind turbines. Part 1: Design requirements
•IEC 61400-1:2005
Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
•EN 61800-3:2004 +
A1:2012
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy.
•EN 61800-5-1:2007
Requirements for electrical installations
•BS7671
Enclosures for Electrical Equipment (1000 Volts Maximum)
•NEMA 250:2003
Adjustable Speed Electrical Power Drive Systems - Part 5-1: Safety Requirements
- Electrical, Thermal and Energy. See section
ETL marking (page 101) .
•UL 61800-5-1
Guideline for Certification of Wind Turbines
•GL-IV-1:2010
CE marking
A CE mark is attached to the converter to verify that the converter follows the provisions of
the European Low Voltage Directive 2014/35/EU (previously 2006/95/EC) and EMC Directive
2014/30/EU (previously 2004/108/EC).
￭
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1 and applicable parts of standard EN 60204-1.
￭
Compliance with the European EMC Directive
See section Compliance with EN 61800-3:2004/A1:2012 (page 100) .
Compliance with the European Machinery Directive
Note: In standard texts, the term 'drive' stands for 'converter' in case of wind turbine
applications.
The drive is an electronic product which is covered by the European Low Voltage Directive.
The drive is equipped with a main circuit breaker which can be used in safety functions for
machinery. These safety functions are in the scope of the Machinery Directive as safety
components, and appropriate harmonized standards (EN ISO 13849 or EN 62061) shall be
applied.
Technical data 99