ABB ACS880-14, Hardware Manual

Page: 198 / 248

RCM mark
Product complies with Australian and New Zealand requirements specific to EMC, telecommunica-
tions and electrical safety. For fulfilling the EMC requirements, see the additional information con-
cerning the drive EMC compliance (IEC/EN 61800-3).
KC mark
Product complies with Korea’s product safety requirements for electrical and electronic equipment
and components that utilize power from 50…1000 V AC.
WEEE mark
At the end of life the product should enter the recycling system at an appropriate collection point
and not placed in the normal waste stream.
EMC compliance (IEC/EN 61800-3:2004)
￭
Definitions
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment. Likewise,
the equipment must not disturb or interfere with any other product or system within its locality.
First environment includes establishments connected to a low-voltage network which supplies
buildings used for domestic purposes.
Second environment includes establishments connected to a network not supplying domestic
premises.
Drive of category C1 : drive of rated voltage less than 1000 V and intended for use in the
first environment.
Drive of category C2 : drive of rated voltage less than 1000 V and intended to be installed
and started up only by a professional when used in the first environment.
Note: A professional is a person or organization having necessary skills in installing and/or
starting up power drive systems, including their EMC aspects.
Drive of category C3 : drive of rated voltage less than 1000 V and intended for use in the
second environment and not intended for use in the first environment.
Drive of category C4 : drive of rated voltage equal to or above 1000 V, or rated current equal
to or above 400 A, or intended for use in complex systems in the second environment.
￭
Category C2
The drive complies with the standard with the following provisions:
1. The drive is equipped with EMC E202 / ARFI-10 and common mode filter (+E208).
2. The motor and control cables are selected as specified in the hardware manual.
3. The drive is installed according to the instructions given in the hardware manual.
4. Maximum motor cable length is 150 meters.
198 Technical data