ABB ACS880-04F, Quick Installation And Start-Up Manual

Page: 7 / 36

Quick installation and start-up
instructions
Contents of this chapter
This chapter tells you briefly how to install the drive module into a cabinet. For more
detailed instructions, engineering guide lines, technical data and complete safety
instructions, see the hardware manual
3AXD50000034664 [English]).
Obey the safety instructions
￭
General safety
These instructions are for all personnel who do work on the drive.
WARNING!
Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
• Keep the drive in its package until you install it. After unpacking, protect the drive
from dust, debris and moisture.
• Use the required personal protective equipment: safety shoes with metal toe cap,
safety glasses, protective gloves and long sleeves, etc. Some parts have sharp
edges.
• Lift a heavy drive with a lifting device. Use the designated lifting points.
• Obey the local laws and regulations applicable to lifting, such as requirements for
planning the lifting, for capacity and condition of lifting equipment, and for training
of personnel.
• Attach the drive cabinet to the floor to prevent it from falling over. The cabinet
has a high center of gravity. Attach the cabinet also to the wall when necessary.
• Do not do work on the drive when a rotating permanent magnet motor is
connected to it. A rotating permanent magnet motor energizes the drive, including
its input and output terminals.
• Make sure that debris from drilling, cutting and grinding does not enter the drive.
Quick installation and start-up instructions 7