ABB ACS880-04F-504A-3, Hardware Manual

Page: 64 / 202

• If motor power is below 350 kW: Equip the drive and/or motor with the filters
and/or bearings according to the table below.
• If motor power is above 350 kW: Consult the motor manufacturer.
Requirement for Nominal AC supply
voltage
ABB d u/dt and common mode filters, insulated N-
end motor bearings
Motor insulation system
100 kW <
P
n
< 350 kW or
IEC 315 < frame size < IEC
400
P
n
< 100 kW or frame size
< IEC 315
134 hp < P
n
< 469 hp or
NEMA 500 < frame size <
NEMA 580
P
n
< 134 hp or frame size
< NEMA 500
+ N or CMF + N or CMF Standard: Û
LL
= 1300 V U
n
≤ 420 V
+ N + d u/dt + CMF + d u/dt + (N or CMF) Standard: Û
LL
= 1300 V 420 V < U
n
< 500 V
or
+ N or CMF + N or CMF Reinforced: Û
LL
= 1600 V,
0.2 microsecond rise time
+ N + d u/dt + CMF + d u/dt + (N or CMF) Reinforced: Û
LL
= 1600 V 500 V < U
n
≤ 600 V
or
+ N + CMF + N or CMF Reinforced: Û
LL
= 1800 V
+ N + d u/dt + CMF + N + d u/dt Reinforced: Û
LL
= 1800 V 600 V < U
n
≤ 690 V
+ N + CMF + N + CMF
Reinforced: Û
LL
= 2000 V,
0.3 microsecond rise
time
1)
1) If the intermediate DC circuit voltage of the drive is increased from the nominal level due to long term resistor
braking cycles, check with the motor manufacturer if additional output filters are needed.
Additional data for calculating the rise time and the peak line-to-line voltage
The diagrams below show the relative peak line-to-line voltage and rate of change of
voltage as a function of the motor cable length. If you need to calculate the actual
peak voltage and voltage rise time considering the actual cable length, proceed as
follows:
• Peak line-to line voltage: Read the relative
Û
LL
/
U
n
value from the diagram below
and multiply it by the nominal supply voltage ( U
n
).
• Voltage rise time: Read the relative values
Û
LL
/
U
n
and (d
u/dt)/U
n
from the diagram
below. Multiply the values by the nominal supply voltage (
U
n
) and substitute into
equation t = 0.8 · Û
LL
/(d u/dt).
64 Guidelines for planning the electrical installation