ABB ACS880-01 Series, Hardware Manual

Page: 84 / 224

84 Electrical installation
Connecting the power cables
„
Connection diagram
1 For alternatives, see section Selecting the supply disconnecting device on page 53.
2 Use a separate grounding PE cable (2a) or a cable with a separate PE conductor (2b)
if the conductivity of the shield does not meet the requirements for the PE conductor
(see page
63 ).
3 360-degree grounding is recommended if shielded cable is used. Ground the other end
of the input cable shield or PE conductor at the distribution board.
4 360-degree grounding is required.
5 External brake resistor
6 Use a separate grounding cable if the shield does not meet the requirements of
IEC 61439-1 (see page
63 ) and there is no symmetrically constructed grounding
conductor in the cable (see page 68 ).
7 du/dt filter or sine filter (optional, see page 221 ).
Note:
If there is a symmetrically constructed grounding conductor on the motor cable in addition to
the conductive shield, connect the grounding conductor to the grounding terminal at the drive
and motor ends.
Do not use an asymmetrically constructed motor cable for motors above 30 kW (see page
63 ).
Connecting its fourth conductor at the motor end increases bearing currents and causes extra
wear.
L1 L2 L3 T1/U T2/V T3/W
UDC+
R+
UDC-
R-
L1 L2 L3 (PE) (PE) PE
ACS880-01
PE
U1
V1
W1
3 ~ M
1
2a
2b
3
5
6
7
4 3
ACS880-01 HW.book Page 84 Monday, July 1, 2013 4:51 PM