ABB ACS860, Firmware Manual

Page: 251 / 438

Parameters 251
50.05 FBA A ref2 type Selects the type and scaling of reference 2 received from
fieldbus adapter A.
See parameter
50.04 FBA A ref1 type .
Auto
50.07 FBA A actual 1 type Selects the type/source and scaling of actual value 1
transmitted to the fieldbus network through fieldbus adapter A.
Note: Fieldbus-specific communication profiles may use
different scalings. For more information, see the manual of the
fieldbus adapter.
Auto
Auto Type/source and scaling follow the type of reference 1
selected by parameter
50.04 FBA A ref1 type . See the
individual settings below for the sources and scalings.
0
Transparent The value selected by parameter 50.10 FBA A act1
transparent source is sent as actual value 1. No scaling is
applied (the 16-bit scaling is 1 = 1 unit).
1
General The value selected by parameter 50.10 FBA A act1
transparent source is sent as actual value 1 with a 16-bit
scaling of 100 = 1 unit (ie. integer and two decimals).
2
Torque 01.10 Motor torque is sent as actual value 1. The scaling is
defined by parameter 46.03 Torque scaling .
3
Speed 01.01 Motor speed used is sent as actual value 1. The scaling
is defined by parameter 46.01 Speed scaling .
4
Frequency 01.06 Output frequency is sent as actual value 1. The scaling
is defined by parameter 46.02 Frequency scaling .
5
50.08 FBA A actual 2 type Selects the type/source and scaling of actual value 2
transmitted to the fieldbus network through fieldbus adapter A.
See parameter
50.07 FBA A actual 1 type .
Auto
50.09 FBA A SW
transparent source Selects the source of the fieldbus status word when the
fieldbus adapter is set to a transparent communication profile
eg. by its configuration parameters (group
51 FBA A settings ).
Not selected
Not selected No source selected. -
Other Source selection (see Terms and abbreviations on page 92 ). -
50.10 FBA A act1
transparent source When parameter 50.07 FBA A actual 1 type is set to
Transparent or General , this parameter selects the source of
actual value 1 transmitted to the fieldbus network through
fieldbus adapter A.
Not selected
Not selected No source selected. -
Other Source selection (see Terms and abbreviations on page 92 ). -
50.11 FBA A act2
transparent source When parameter 50.08 FBA A actual 2 type is set to
Transparent or General , this parameter selects the source of
actual value 2 transmitted to the fieldbus network through
fieldbus adapter A.
Not selected
Not selected No source selected. -
Other Source selection (see Terms and abbreviations on page 92 ). -
50.12 FBA A debug mode Enables the display of raw (unmodified) data received from
and sent to fieldbus adapter A in parameters
50.13 … 50.18 .
This functionality should only be used for debugging.
Note: This parameter cannot be changed while the drive is
running.
Disable
Disable Display of raw data from fieldbus adapter A disabled. 0
Fast Display of raw data from fieldbus adapter A enabled. 1
No. Name/Value Description Def / FbEq16