ABB ACS850 series, Firmware Manual

Page: 80 / 260

80 Parameters
10.02 Ext1 start in1 Selects source 1 of start and stop commands for external
control location EXT1. See parameter
10.01 Ext1 start func ,
selections In1 and 3-wire.
Note: This parameter cannot be changed while the drive is
running.
DI1 Digital input DI1 (as indicated by 02.01 DI status , bit 0). 1073742337
DI6 Digital input DI1 (as indicated by 02.01 DI status , bit 5). 1074070017
DIO4 Digital input/output DIO4 (as indicated by 02.03 DIO status ,
bit 3).
1073938947
Timed func Bit 4 of parameter 06.14 Timed func stat . The bit is on when
at least one of the four timers configured in parameter group
36 Timed functions is on.
1074005518
Const Constant and bit pointer settings (see Terms and
abbreviations on page 63 ).
-
Pointer
10.03 Ext1 start in2 Selects source 2 of start and stop commands for external
control location EXT1. See parameter
10.01 Ext1 start func ,
selection 3-wire.
Note: This parameter cannot be changed while the drive is
running.
DI2 Digital input DI2 (as indicated by 02.01 DI status , bit 1). 1073807873
DI5 Digital input DI5 (as indicated by 02.01 DI status , bit 4). 1074004481
DIO5 Digital input/output DIO5 (as indicated by 02.03 DIO status ,
bit 4).
1074004483
Const Bit pointer setting (see Terms and abbreviations on page 63 ). -
Pointer
10.04 Ext2 start func Selects the source of start and stop commands for external
control location 2 (EXT2).
Note: This parameter cannot be changed while the drive is
running.
Not sel No start or stop command sources selected. 0
In1 The source of the start and stop commands is selected by
parameter
10.05 Ext2 start in1 . The state transitions of the
source bit are interpreted as follows:
1
3-wire The sources of the start and stop commands is selected by
parameters
10.05 Ext2 start in1 and 10.06 Ext2 start in2 . The
state transitions of the source bits are interpreted as follows:
2
FBA The start and stop commands are taken from the fieldbus. 3
No. Name/Value Description FbEq
State of source
(via par
10.05 )
Command
0 -> 1 Start
1 -> 0 Stop
State of source 1
(via par.
10.05 )
State of source 2
(via par.
10.06 )
Command
0 -> 1 1 Start
Any 1 -> 0 Stop
Any 0 Stop