ABB ACS850-04 series, Firmware Manual

Page: 64 / 296

64 Program features
Note: Jogging is not operational when the drive start command is on, or if
the drive is in local control.
Note: The ramp shape time is set to zero during jogging.
Load analyzer
„
Peak value logger
The user can select a signal to be monitored by the peak value logger. The logger
records the peak value of the signal along with the time the peak occurred, as well as
motor current, DC voltage and motor speed at the time of the peak.
„
Amplitude loggers
The drive has two amplitude loggers.
2-3 1 1 0 Drive runs at the jogging speed.
3-4 0 1 0 Drive decelerates to zero speed along the deceleration ramp
of the jogging function.
4-5 0 1 0 Drive is stopped.
5-6 1 1 0 Drive accelerates to the jogging speed along the acceleration
ramp of the jogging function.
6-7 1 1 0 Drive runs at the jogging speed.
7-8 x 0 1 Jog enable is not active; normal operation continues.
8-9 x 0 1 Normal operation overrides the jogging. Drive follows the
speed reference.
9-10 x 0 0 Drive decelerates to zero speed along the active deceleration
ramp.
10-11 x 0 0 Drive is stopped.
11-12 x 0 1 Normal operation overrides the jogging. Drive accelerates to
the speed reference along the active acceleration ramp.
12-13 1 1 1 Start command overrides the jog enable signal.
13-14 1 1 0 Drive decelerates to the jogging speed along the
deceleration ramp of the jogging function.
14-15 1 1 0 Drive runs at the jogging speed.
15-16 x 0 0 Drive decelerates to zero speed along the deceleration ramp
of the jogging function.
Phase
Jog
cmd
Jog
enable
Start
cmd
Description