ABB ACS580-01 drives, Hardware Manual

Page: 33 / 226

Operation principle and hardware description 33

External control connection terminals, frame R5…R9
The layout of the external control connection terminals of frames R5…R9 is shown
below.
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Digital inputs
X4 Safe torque off connection
X5 Connection to embedded EIA-
485 fieldbus adapter module
(installed in option slot 3)
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 Ex24 V AC/DC input
connection
X12 Panel connection
X13 Option slot 1 (fieldbus adapter
modules)
X14 Option slot 2 (I/O extension
modules)
X15 Option slot 3 (embedded EIA-
485 fieldbus adapter module)
X16 Auxiliary fan 1 connection
X17 Auxiliary fan 2 connection
S1, S2 Voltage/Current selection
switches for analog input 1 (S1)
and analog input 2 (S2), see
section
Switches on page 100 .
S3 Voltage/Current selection
switch for analog output 1, see
section
Switches on page 100 .
S4, S5 Termination switch (S4), bias
resistor switch (S5), see section
Switches on page 100
1 Panel port (control panel
connection)
2 Cold configuration connection.
This connector is used with the
CCA-01 configuration adapter.
3 Power OK and Fault LEDs. See
section
LEDs on page 130 .
R5…R9
X2
X4
X1:1…3
X1:4…6
X1:7…9
X3:1…3
X3:4…6
X13
1
2
3
X8
X7
X6
X10
X15
X5
S4, S5
X17 X16
X14
S3
S2
S1
X12