ABB ACS580-01 drives, Hardware Manual

Page: 148 / 226

148 Technical data
Terminal and lead-through data for the control cables
Control cable lead-throughs, wire sizes and tightening torques ( T ) are given below.
Frame
size
Cable lead-
throughs
R+, R-, UDC+ and UDC- terminals
Per
cable
type
Ø
1)
Min wire
size (solid/
stranded)
3)
Max wire
size (solid/
stranded)
T (Wire screw)
pcs mm mm
2
mm
2
M… N·m
R0 1 23 0.20/0.25 6/4
2)
0.5…0.6
R1 1 23 0.20/0.25 6/4
2)
0.5…0.6
R2 1 23 0.5/0.5 16/16
2)
1.2…1.5
R3 1 23 0.5/0.5 35/25
2)
2.5…4.1
R4 1 39 0.5/0.5 50 4
R5 1 32 6 70 M8 5.6
R6 1 45 25 150 M8 20
R7 1 54 95 240 M10 30
R8 2 45 2×50 2×150 M10 40
R9 2 54 2×95 2×240 M12 70
3AXD00000586715.xls G
1)
Maximum cable diameter accepted. For the lead-through plate hole
diameters, see chapter Dimension drawings on page 167 .
2)
See the table above.
3)
Note: Minimum wire size does not necessarily have enough current
capability for full load. Make sure the installation complies with local laws and
regulations.
Frame
size
Cable lead-
throughs
Control cable entries and terminal sizes
Holes Max
cable
size
+24V, DCOM, DGND, EXT. 24V DI, AI/O, AGND, RO, STO
terminals
Wire size T Wire size T
pcs mm mm
2
N·m mm
2
N·m
R0 3 17 0.2…2.5 0.5…0.6 0.14…1.5 0.5…0.6
R1 3 17 0.2…2.5 0.5…0.6 0.14…1.5 0.5…0.6
R2 3 17 0.2…2.5 0.5…0.6 0.14…1.5 0.5…0.6
R3 3 17 0.2…2.5 0.5…0.6 0.14…1.5 0.5…0.6
R4 4 17 0.2…2.5 0.5…0.6 0.14…1.5 0.5…0.6
R5 3 17 0.14…2.5 0.5…0.6 0.14…2.5 0.5…0.6
R6 4 17 0.14…2.5 0.5…0.6 0.14…2.5 0.5…0.6
R7 4 17 0.14…2.5 0.5…0.6 0.14…2.5 0.5…0.6
R8 4 17 0.14…2.5 0.5…0.6 0.14…2.5 0.5…0.6
R9 4 17 0.14…2.5 0.5…0.6 0.14…2.5 0.5…0.6
3AXD00000586715.xls G