ABB ACS355 series, User Manual

Page: 179 / 436

Actual signals and parameters 179
12
Actual signals and parameters
What this chapter contains
The chapter describes the actual signals and parameters and gives the fieldbus
equivalent values for each signal/parameter. It also contains a table of the default
values for the different macros.
Terms and abbreviations
Fieldbus addresses
For FCAN-01 CANopen adapter module, FDNA-01 DeviceNet adapter module,
FECA-01 EtherCAT adapter module, FENA-01 Ethernet adapter module, FEPL-02
Ethernet POWERLINK adapter module, FMBA-01 Modbus adapter module, FLON-
01 LonWorks® adapter module, and FPBA-01 PROFIBUS DP adapter module, see
the user’s manual of the adapter module.
Term Definition
Actual signal Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01…04 contain actual signals.
Def Parameter default value
Parameter A user-adjustable operation instruction of the drive. Groups 10…99 contain
parameters.
Note: Parameter selections are shown on the basic control panel as integer
values. For example, parameter 1001 EXT1 COMMANDS selection COMM
is shown as value 10 (which is equal to the fieldbus equivalent FbEq).
FbEq Fieldbus equivalent: The scaling between the value and the integer used in
serial communication.
E Refers to types 01E- and 03E- with European parametrization
U Refers to types 01U- and 03U- with US parametrization