ABB ACS320 series, User Manual

Page: 212 / 442

212 Actual signals and parameters

Group 33: Information
This group provides access to information about the drive’s current programs:
versions and test date.
3208
SUPERV 3 LIM LO
Depends on selection 100.0
Sets the low limit for the third supervised parameter. See parameter 3207 SUPERV 3
PARAM above. Supervision wakes up if the value is below the limit.
3209 SUPERV 3 LIM HI Depends on selection 100.0
Sets the high limit for the third supervised parameter. See parameter 3207 SUPERV 3
PARAM above. Supervision wakes up if the value is above the limit.
Group 33: Information
Code Description Range Resolution Default S
3301 FIRMWARE 10000…FFFF hex 1 Firmware
ver.
Contains the version of the drive’s firmware.
3302 LOADING PACKAGE 0000…FFFF hex 1 0
Contains the version of the loading package.
3303 TEST DATE yy.ww 1 0
Contains the test date (yy.ww).
3304 DRIVE RATING - - -
Indicates the drive’s current and voltage rating. The format is XXXY hex, where:
• XXX =The nominal current rating of the drive in amps. If present, an “A” indicates a
decimal point in the rating for the current. For example XXX = 9A8 indicates a
nominal current rating of 9.8 amperes.
• Y = The voltage rating of the drive, where Y = :
• 2 indicates a 200…240 Volt rating.
• 4 indicates a 380…480 Volt rating.
• 6 indicates a 500…600 Volt rating.
3305 PARAMETER TABLE 0000…FFFF hex
Contains the parameter table version of the drive’s firmware.
Group 32: Supervision
Code Description Range Resolution Default S