ABB ACS310, User Manual

Page: 71 / 376

Control panels 71

Operation
You can operate the control panel with the help of menus and keys. You can select an
option, for example, an operation mode or parameter, by scrolling the
and
arrow keys until the option is visible on the display and then pressing the key.
With the key, you can return to the previous operation level without saving the
made changes.
The Basic control panel has five panel modes: Output mode , Reference mode ,
Parameter mode , Copy mode and Fault mode. The operation in the first four modes
is described in this chapter. When a fault or alarm occurs, the panel goes
automatically to the Fault mode showing the fault or alarm code. You can reset the
fault or alarm in the Output or Fault mode (see chapter
Fault tracing on page 311 ).
After the power is switched on, the panel is in the
Output mode, where you can start, stop, change the
direction, switch between local and remote control and
monitor up to three actual values (one at a time). To do
other tasks, go first to the Main menu and select the
appropriate mode.
How to perform common tasks
The table below lists common tasks, the mode in which you can perform them and the page
number where the steps of the task are described in detail.
Task Mode Page
How to find out the panel firmware version At power up 72
How to switch between local and remote control Any 72
How to start and stop the drive Any 72
How to change the direction of the motor rotation Any 73
How to browse the monitored signals Output 74
How to set the frequency reference Reference 75
How to change the value of a parameter Parameter 76
How to select the monitored signals Parameter 77
How to reset faults and alarms Output, Fault 311
How to copy parameters from the drive to the control panel Copy 79
How to restore parameters from the control panel to the drive Copy 79
REM Hz
OUTPUT FWD
491
.
REM
MENU FWD
PAr
Aotewell Ltd www.aotewell.com Industry Automation
HongKong|UK|China sales@aotewell.com +86-755-8660-6182