ABB ACS2000 AFE 2MVA, User Manual

Page: 149 / 181

149 ACS2000 AFE 2MVA UM 3BHS355653 ZAB E01 REV. H
—
9.8 Drive selection mode
The local / remote feature of the CDP control panel allows selecting
the control location of the drive.
9.8.1 Overview
The drive selection mode is used to connect the
CDP control panel either to the AMC circuit board
of the AFE, or the INU of the drive.
—
In this context, the AMC circuit
board of the AFE and INU is
referred to as a drive that is iden-
tified in the control system by its
ID number:
• ID number of INU: 1
• ID number of AFE: 2.
Status line
Device type
Application SW version
Drive identification
Selection key for drive mode
Slow navigation key for selecting the AMC cir-
cuit board (AFE or INU)
Enter key for confirming the selection
9.8.2 Selecting an AMC circuit board
—
It is assumed in the following
example that the CDP control
panel is connected to the INU.
1. To enter the drive mode, press the DRIVE key.
2. To select the ID number of the AFE and to con-
nect the CDP control panel to the AFE, press any
of the slow navigation keys.
If none of the keys is pressed, the display auto-
matically returns to the actual signals display
after a while.
If the ID number of the AFE or INU is changed by
accident (eg, to 3) and the ENTER key has been
pressed, the new number is saved in the mem-
ory. The display still shows the old number. Only
when the auxiliary voltage has been switched
off and on again, the new number is shown on
the display.
If the ID number is changed by accident, simply
change the ID number back and press the
ENTER key. The ID number is restored when the
auxiliary power is switched off and on the next
time.
ACS2000 AFE
6k SingleINU
LDAI5500
ID-Number
1
1
3
2
4
5
6
7
1
2
3
4
5
6
7
6k SingleINU
LDAI5500
ID-Number
1
ACS2000AD
6k SingleAFE
LBAI5120
ID-Number
2
ACS2000AFE