PREVENTIVE AND CORRECTIVE MAINTENANCE
PRODUCT
ACS1000W
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS213400 E01
REV.
J
LANG.
en
PAGE
157/166
11.6.8. Checking wire and cable connections
11.6.9. Cleaning and replacing filter mats
This section applies to a drive without enclosure cooler in the water cooling
compartment.
For information on inspection and replacement intervals, see “ACS1000 preventive
maintenance schedule” (3BHS855276 E01).
NOTICE
Risk of component damage.
Capacitor bushings are damaged when excessive force is applied.
–
DO NOT exceed the maximum tightening torque.
•
The tightening torque value is printed on a label which is attached
to the capacitor.
•
If not specified, the maximum torque must not exceed 20 Nm.
Vibration can loosen electrical connections and cause occasional
malfunction or equipment failure.
–
Check all power and control cable connections and tighten them
if necessary.
–
Check that all plugs and connectors are tight.
WARNING
Hazardous voltage!
Removing the filter mat while the drive is running can cause serious injury
or DEATH.
–
Make sure that long, thin objects, such as wires and screwdrivers, DO
NOT enter the air intake of a medium voltage compartment. These
objects can cause FATAL short-circuits.
–
To prevent foreign matter from entering the air intake, DO NOT stop
work for lengthy periods.
