ABB ACS 800 Series, Firmware Manual

Page: 214 / 340

Actual signals and parameters
214
85.09 CONSTANT9 Sets a constant for the Adaptive Program.
-8388608 to 8388607 Integer value 1 = 1
85.10 CONSTANT10 Sets a constant for the Adaptive Program.
-8388608 to 8388607 Integer value 1 = 1
85.11 STRING1 Stores a message to be used in the Adaptive Program (EVENT block).
MESSAGE1 Message -
85.12 STRING2 Stores a message to be used in the Adaptive Program (EVENT block).
MESSAGE2 Message -
85.13 STRING3 Stores a message to be used in the Adaptive Program (EVENT block).
MESSAGE3 Message -
85.14 STRING4 Stores a message to be used in the Adaptive Program (EVENT block).
MESSAGE4 Message -
85.15 STRING5 Stores a message to be used in the Adaptive Program (EVENT block).
MESSAGE5 Message -
90 D SET REC ADDR
- Addresses into which the received fieldbus data sets are written.
- Numbers of the main and auxiliary data sets.
The parameters are visible only when a fieldbus communication is activated
with parameter
98.02 . For more information, see chapter Fieldbus control .
90.01 AUX1 DS REF3 Selects the address into which the value of fieldbus reference REF3 is written.
0 … 8999 Parameter index
90.02 AUX1 DS REF4 Selects the address into which the value of fieldbus reference REF4 is written.
0 … 8999 Parameter index
90.03 AUX1 DS REF5 Selects the address into which the value of fieldbus reference REF5 is written.
0 … 8999 Parameter index
90.04 AUX2 DS REF6 Selects the address into which the value of fieldbus reference REF6 is written.
0 … 8999 Parameter index
90.05 AUX2 DS REF7 Selects the address into which the value of fieldbus reference REF7 is written.
0 … 8999 Parameter index
90.06 AUX2 DS REF8 Selects the address into which the value of fieldbus reference REF8 is written.
0 … 8999 Parameter index
90.07 START DS REC Defines the starting data set from which the drive reads the Control Word,
Reference REF1 and Reference REF2.
1 Data set number 1 is the starting address. Can be used for standard drives. 1
10 Data set number 10 is the starting address. Can be used for multidrives. 2
92 D SET TR ADDR
Main and Auxiliary Data Sets which the drive sends to the fieldbus master
station.
The parameters are visible only when a fieldbus communication is activated
with parameter
98.02 . For more information, see chapter Fieldbus control .
92.01 MAIN DS STATUS
WORD Stores the address from which the Main Status Word is read from. Fixed value,
not visible.
302 (fixed) Parameter index
92.02 MAIN DS ACT1 Selects the address from which the Actual signal 1 is read to the Main Data
Set.
0 … 9999 Parameter index
Index Name/Selection Description FbEq