ABB ACS 800 Series, Firmware Manual

Page: 201 / 340

Actual signals and parameters
201
50.07 ENC CABLE CHECK Selects the drive operation when encoder signal is missing.
Note: Monitoring is only for RTAC-03. For more information, see RTAC-03
TTT Pulse Encoder Interface Module User’s Manual [3AFE68650500
(English)]
DISABLED Not active 1
WARNING Drive generates warning ENC CABLE. 2
FAULT The drive trips on ENC CABLE. 3
51 COMM MODULE
DATA
The parameters are visible and need to be adjusted, only when a fieldbus
adapter module (optional) is installed and activated with parameter
98.02 . For
details on the parameters, refer to the manual of the fieldbus module and
chapter
Fieldbus control .
These parameter settings will remain the same even though the macro is
changed.
52 STANDARD
MODBUS The settings for the Standard Modbus Link. See chapter Fieldbus control .
52.01 STATION NUMBER Defines the address of the device. Two units with the same address are not
allowed on-line.
1 … 247 Address 1 = 1
52.02 BAUDRATE Defines the transfer rate of the link.
600 600 bit/s 1
1200 1200 bit/s 2
2400 2400 bit/s 3
4800 4800 bit/s 4
9600 9600 bit/s 5
19200 19200 bit/s 6
52.03 PARITY Defines the use of parity and stop bit(s). The same setting must be used in all
on-line stations.
NONE1STOPBIT No parity bit, one stop bit 1
NONE2STOPBIT No parity bit, two stop bits 2
ODD Odd parity indication bit, one stop bit 3
EVEN Even parity indication bit, one stop bit 4
60 MASTER/
FOLLOWER Master/Follower application. For more information, see section Master/
Follower use of several drives (Only in EXT2 Control) on page 94 and a
separate Master/Follower Application Guide [3AFE64590430 (English)].
60.01 MASTER LINK MODE Defines the role of the drive on the Master/Follower link.
Note: Master/Follower configuration will work with complete functionality only
when the drive is in EXT2 control. EXT1 control can be used for the drive to be
a stand-alone drive with M/F link active.
Two Master stations are not allowed on-line. If a Follower drive is changed to
be a Master drive (or vice versa) with this parameter, the RMIO board must be
powered up again for the M/F link to work properly.
NOT IN USE The Master/Follower link is not active. 1
MASTER Master drive 2
FOLLOWER 1 Follower drive 3
FOLLOWER 2 Follower drive 4
FOLLOWER 3 Follower drive 5
Index Name/Selection Description FbEq