ABB ACQ810, Firmware Manual

Page: 122 / 376

122 Parameters
02.38 EFB main ref1 Internal and scaled reference 1 of the drive received through
the embedded fieldbus interface. See parameter
50.04 FBA
ref1 modesel and chapter Control through the embedded
fieldbus interface on page 329 .
-
02.39 EFB main ref2 Internal and scaled reference 2 of the drive received through
the embedded fieldbus interface. See parameter
50.05 FBA
ref2 modesel and chapter Control through the embedded
fieldbus interface on page 329 .
--
02.40 FBA setpoint Target parameter for writing the setpoint from the fieldbus.
The unit and scaling are defined by parameters
28.06 Act
unit sel and 28.07 Act FBA scaling respectively.
-
02.41 FBA act val Target parameter for writing a feedback value from the
fieldbus. The unit and scaling are defined by parameters
28.06 Act unit sel and 28.07 Act FBA scaling respectively.
-
02.42 Shared DI Status of shared digital inputs received through the drive-to-
drive link.
Example: 00000001 = DI1 is on, DI2…DI6 are off.
See parameters 76.11 … 76.16 .
-
02.43 Shared signal 1 Shows the value of shared signal 1 as received through the
drive-to-drive link. See parameters
76.11 … 76.16 .
-
02.44 Shared signal 2 Shows the value of shared signal 2 as received through the
drive-to-drive link. See parameters
76.11 … 76.16 .
-
No. Name/Value Description FbEq
Bit Name Value Information
(continued)
9
Limit 1 Operation is limited by any of the torque limits.
0 Operation is within the torque limits.
10 Above limit 1 Actual speed exceeds limit defined by parameter 19.08 Above speed
lim .
0 Actual speed is within the defined limits.
11 Ext2 act 1 External control location EXT2 is active.
0 External control location EXT1 is active.
12 Local fb 1 Fieldbus local control is active.
0 Fieldbus local control is inactive.
13 Zero
speed 1 Drive speed is below limit defined by parameter 19.06 Zero speed
limit .
0 Drive has not reached zero speed limit.
14 Rev act 1 Drive is running in reverse direction.
0 Drive is running in forward direction.
15 Reserved
16 Fault 1 A fault is active. See chapter Fault tracing on page 313 .
0 No fault is active.
17 Local
panel 1 Local control is active, i.e. the drive is controlled from PC tool or
control panel.
0 Local control is inactive.
18…26 Reserved
27
Request ctl 1 Control Word is requested from fieldbus.
0 Control Word is not requested from fieldbus.
28 SW B28 Programmable control bits (unless fixed by the used profile). See parameters
50.08 … 50.11 .
29 SW B29
30 SW B30
31 SW B31