ABB ACQ80, Firmware Manual

Page: 15 / 390

Introduction to the manual 15
Drive
Frequency converter for controlling AC induction motors and
permanent magnetic motors for water pump applications.
EFB
Embedded fieldbus
FBA
Fieldbus adapter
FPBA-01
Optional PROFIBUS DP adapter module
FMBT-21
Optional Modbus/TCP adapter module
FSCA-01
Optional RS-485 adapter module
FEIP-21
Optional EtherNet/IP adapter module
FCAN-01
Optional CANopen adapter module
FECA-01
Optional EtherCAT adapter module
FPNO-21
Optional two port PROFINET adapter module
Frame (size)
Refers to drive physical size, for example R0 and R1. The type
designation label attached to the drive shows the frame of the drive,
see chapter
Operation principle and hardware description,
section
Type designation label in the hardware manual of the drive.
IGBT
Insulated gate bipolar transistor: used for high efficiency and fast
switching
Intermediate
circuit
See
DC link
.
Inverter
Converts direct current and voltage to alternating current and
voltage.
I/O
Input/Output
LSW
Least significant word
Macro
Pre-defined default values of parameters in drive control program.
Each macro is intended for a specific application. See chapter
Control
macros
on page
75
.
MPPT
Maximum power point tracking
NETA-21
Remote monitoring tool
Network control
With fieldbus protocols based on the Common Industrial Protocol
(CIP
TM
), such as Ethernet/IP, denotes the control of the drive using
the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive Profile. For
more information, see
www.odva.org,
and the following manual:
FENA-01/-11/-21 Ethernet adapter module user’s manual
(3AUA0000093568 [English]).
Parameter
User-adjustable operation instruction to the drive, or signal
measured or calculated by the drive
PID/Loop
controller
Proportional–integral–derivative controller. Drive speed control is
based on PID algorithm.
PLC
Programmable logic controller
Term/
abbreviation Explanation