ABB ACQ580, Firmware Manual

Page: 405 / 422

Fieldbus control through a fieldbus adapter 401

Parameter setting example: FPBA (PROFIBUS DP)
This example shows how to configure a basic speed control application that uses the
PROFIdrive communication profile with PPO Type 2. The start/stop commands and
reference are according to the PROFIdrive profile, speed control mode.
The reference values sent over the fieldbus have to be scaled within the drive so they
have the desired effect. The reference value ±16384 (4000h) corresponds to the
range of speed set in parameter
46.01 Speed scaling (both forward and reverse
directions). For example, if 46.01 is set to 480 rpm, then 4000h sent over fieldbus will
request 480 rpm.
The table below gives the recommended drive parameter settings.
Direction PZD1 PZD2 PZD3 PZD4 PZD5 PZD6
Out Control word Speed reference Acc time 1 Dec time 1
In Status word Speed actual value Motor current DC voltage
Drive parameter Setting for ACX580
drives Description
50.01 FBA A enable 1 = [slot number] s communication between the drive and
the fieldbus adapter module.
50.04 FBA A ref1 type 4 = Speed Selects the fieldbus A reference 1 type
and scaling.
50.07 FBA A actual 1 type 0 = Speed or
frequency
Selects the actual value type and scaling
according to the currently active Ref1
mode defined in parameter
50.04 .
51.01 FBA A type 1 = FPBA
1)
Displays the type of the fieldbus adapter
module.
51.02 Node address 3
2)
Defines the PROFIBUS node address of
the fieldbus adapter module.
51.03 Baud rate 12000
1)
Displays the current baud rate on the
PROFIBUS network in kbit/s.
51.04 MSG type 1 = PPO2
1)
Displays the telegram type selected by
the PLC configuration tool.
51.05 Profile 0 = PROFIdrive Selects the Control word according to the
PROFIdrive profile (speed control mode).
51.07 RPBA mode 0 = Disabled Disables the RPBA emulation mode.
52.01 FBA data in1 4 = SW 16bit
1)
Status word
52.02 FBA data in2 5 = Act1 16bit Actual value 1
52.03 FBA data in3 01.07
2)
Motor current
52.05 FBA data in5 01.11
2)
DC voltage
53.01 FBA data out1 1 = CW 16bit
1)
Control word
53.02 FBA data out2 2 = Ref1 16bit Reference 1 (speed)
53.03 FBA data out3 23.12
2)
Acceleration time 1